Welcome to use PX series DMX512 decoder & driver. PX series adopt the advanced micro-computer control technology and converted the DMX512/1990 digital signal widely used in international to the analog control signal. 1~3 channels output for option and each channel able to achieve 256 gradations of controling, and also it can be used as the connector of PC digital light controller and analog light modulator. It is mainly used for the controlling of buildings & lights applied LED.
Features
Meets DMX512/1990
256-level brightness,full-color control
With 3 channels output and Max.3A/CH output
With control system,can express perfect effect
With the light color selected mechanism, and be able to control the light with 1~3 colors
Can set the DMX address freely
Can be custom-made
Meets DMX512/1990
Can drive 3A(Each CH.)
Can drive many kinds of LED lamps
Specification
Decode CH.: 3CH
Input Signal: DMX-512/1990 digital signal Output Signal: can drive 3A(Each CH.) Power Supply: DC 12~24V
Power Dis.: <1W
Power Output: <216W(24V);<108W(12V)
Operating Temp.: 0~50℃
Size: 86(mm)*51(mm)*17.8(mm)
Weight: 110g
DIMENSION
Appearance
(1) DMX signal input interface
(2) DMX signal output interface
(3) Power input interface
(4) Address setting interface
(5) Driver output interface
Interface Introduction
DMX signal interface Input and output interfaces can be interchanged for using
TYPICAL APPLICATIONS
Circuit Diagram 1
Address setting interface: How to use See "DMX series of addresses dial code table"
Addresses dial code table of DMX series: DC 12-24V input,supply power for decoder and the lamps it takes.
Driver output interface: Common anode,V+ and R,G,B interface,can drive kinds of RGB module or single-color module, Can regulate output current according to the actual load.
Remark
Connect the anode and RGB wire of common anode RGB module to the output interface of decoder directly; Connect the anode wire of single-color module to V+ on decoder,and connect the cathode wire to one of RGB pin according to the LED's color; Connect several colors single-color module to one decoder,please connect their anode wires to V+ pin on decoder.
Connecting of DMX-512 Signal
DMX signal cable used the CAT-5 cable or three-core shielded cable,and DMX signal has the positive(+) pole and negative (-) pole. While welding the DMX signal cable plug,there must pay much attention to distinguish between postive(+) and negative(-), and then connect the DMX512 signal cable with the corresponding input interface of PX24506 correctly.
Connect a signal terminal at the end of the whole connetion(To be PX24506 DIP switches set aside under section 10 can)
Tell us what you think about this item, share your opinion with other people. Please make sure that your review focus on this item. All the reviews are moderated and will be reviewed within two business days. Inappropriate reviews will not be posted.